Flash Brush Cutter 43cc

Have tried all attachments. Cuts thru everything. Starts immediately and idles perfectly.Could be slightly lower revving than my old stihl but engine has plenty of torque. Excellent value for the price.

Finally got it out of the box. The catcher is terrible, no matter how hard you crank it down its still free to move around (yes I found the little hole and the dimple it's still a bad design) have been using it about 3 days and now I can't get the blade off, the screw driver it came with buckled and bent and the blade goes about 20 RPM. Idk what they did to this thing in the revision as its defintely not the same as the one i got a few years ago. They made it way worse. it died after 5 tanks of gas.

It was a great buy, cutes very thing

Good reliable weed eater, easy to start and if you can't be respooling you can't just buy a replacement head easy.

Good machine, gets through the tough stuff.

Bloody great machine cleared a whole acre of thick brush blackberry you name it I thought it wouldn't even make it half way through for the price I paid for it bloody cheap it's still running great even after all the abuse it has gone through only took 20 seconds to put together and away thanks trade tested great product

First one broke on the first use, with the shaft no longer driving the blade. Was sent replacement. The first couple of uses were fine and then started to vibrate so badly that hands go numb after 10 minutes. The motor seems to be very good quality, the shaft far from it.

Great machine. Easy to set up, only suggestion would be to have a sharft that is one piece, as have it broken into 2 pieces the inside rod teeth get worn out quite easlie and fast when doing alot of work.

I have a very overgrown section with gorse and grass 2 foot high, this is really doing a great job of cleaning up the section. I would highly recommend this product.

Turned up missing screws. Customer service requested I source replacements myself. Very difficult to re-string the nylon, have to feed ends through holes while trying to hold spring and washers in place. Connection between the two parts of the shafts is worn after one use, now lower section of the shaft slowly rotates as it is being used.