Keter Factor 6x3 Shed 1.78m x 1.13m

It's a good shed but you need to know a few things. You need 2 people to assemble it without any wind. The roof design fastening is very poor. It will blow off. Use bolts down from the top with large mudguard washers and nuts and washers inside x 8. It is quite floppy and will disappear in a storm. On the inside put a 3x1 across the back, then screw straight thru into a horizontal rail on a fence or wall. Then put another 3x1 on each side on the inside screwing to the rear 3x1. The hinges are tight to fit. Screw in a screw and washer on the inside to pull them thru. Overall it's fine but you have to make it storm proof.

It was the first time putting up a shed and it took 2 of us only a few hours to assemble and we were not rushing. All pieces were included and everything went together easily. We had a lot of fun and a very solid shed.

Thought I was getting a great little shed but can’t complete putting up because doors are rubbish. The panels don’t sit flush with top & bottom of doors. Some clips on the panels are broken which are suppose to hold the panels in place, as well as a couple of hinges won’t sit in the correct place due to a bit of plastic on the door stopping the hinge from being seated properly. Have also noticed one of the doors has bowed, so not confident how that is going to fit correctly. Shed still sitting in a pile going nowhere. I would not buy again. Very disappointed.

They only plus side to this shed is the look. Putting it together was difficult because the corners were bowed so the centre hinges for the doors don't sit tight in the chanel. Every time I open the doors the hinges pop out, to close them I have to push the hinges into the chanel while trying to close the door.

Easy to put up, it’s not leaking and fits perfectly in the corner of my garden, just what I needed

Easily erected and seams like a great shed way better than a flimsy steel shed

I purchased this shed from tradetested. It was easy to put together compared to a tin shed I helped put together a month earlier. Everything just clipped together or screwed together with preset holes. No drilling required. I built a H3 floor so that I had a level surface.

Overall not a bad shed. Instruction manual was easy to follow. Connecting the back wall to roof was fiddly as you had to make sure pieces were secured in place. Word of caution: i dropped a gable end on to ground and it broke so make sure to not drop items as they are brittle. Definitely need two people to erect it.

I wouldn't buy this again. It is all plastic - even big plastic screws to hold the main pieces together. I am usually great at kit set, but this took some work to jiggle the bits around so that the screws could go in. Not impressed.

Excellent product, easy to build but need 2 people would strongly recommend